SUPERCHILL 
Cooling Towers 
|
SUPERCHILL
Cooling Towers
|
|
|
Induced draught, counterflow open wet-type cooling towers with axial fan in compact corrosion-proof fibreglass design. Removable full side access panel for easy maintenance and cleaning. Water flow rates from 2 to 95 m3/h Induced draught, counter flow, open wet-type cooling towers with axial fan in compact corrosion-proof fibreglass design. Water flow rates from 2 to 550 m3/h Induced draught,counter flow, open wet-type cooling towers with suction-type axial fan in compact, corrosion-protected fibreglass design. Extendable construction enables the cooling capacity to be easily upgraded. Water flow rates per unit from 65 to 2200 m3/h EWK-F range closed circuit cooling towers and coolers Induced or forced draught wet-type cooling towers in corrosion-proof fibreglass design with closed primary circuits suitable for cooling a variety of liquids and gases Flow rates per unit from 30 to 240 m3/h EWK-B range bulk air coolers Open wet-type Bulk air coolers with or without suction-type axial fan in compact, corrosion-protected fibreflass design. Especially proven for underground Mines. Water flow rates per unit from 65 to 2200 m3/h 
EWK-D range cooling towers
Corrosion-proof fibreglass design, forced draught, counter flow, open wet-type cooling towers with radial fans. A low-noise level cooling tower, suitable for indoor installation and connection to air feed and discharge ducts. Water flow rates from 7 to 270 m3/h Available types of fill:High-efficiency film pack (in PVC, ABS or PP) 12-mm flute gap ideal for most applications in which water and air are fairly clean. 19-mm flute gap for when the concentration of solids dissolved in the water exceeds 1000 ppm. 27-mm flute gap used when water and air are heavily laden with contaminants. Splashtube
Splashtube (Polyethylene) The answer to fouling in cooling towers. The revolutionary, high temperature, non-fouling SPLASHTUBE encompasses all types of "splash requirements with the efficiency of a trickle grid. Splashtube has been developed for applications in which water or air borne particles of fibres would foul conventional cooling towers. This new cooling-tower filling is particularly suited for use in the mining, chemicals, paper and textiles industries. Splashtube is manufactured from polyethylene tubes with very large apertures that eliminate fouling. The tubes provide bath splash and trickle surfaces for cooling and have been fully thermally tested. The strong lightweight construction and the unique packing method make them extremely easy to remove, clean and reinstall. An additional benefit is the tubular arrangement, with water an air in counter-flow, resulting in a low airside pressure drop. Splashgrid (Also available on request:)Besides the manufacture of custom built fibreglass parts like FRP storage tanks, Superchill Australia can supply and replace a wide range of cooling tower components, such as fill, mist eliminators, water distribution pipework, nozzles fans etc.
|
|
Send mail to bruno@superchill.com with questions or comments about this web site.
|
